Device holder for genos

[Al Ram]

Vali

thanks a lot for your prompt response. 

I believe that you are 100% right.   Althought the tube included in the K&M 232 that you mentioned has a length of 175mm and the tube i was looking at has a lenght of 130mm but the thread should be the same at 3/8.    That means i would need an adapter from 3/8 to 5/8.

This is what i am considering ordering to adapt an iPad Pro 12.9 inches to the Genos.   I currently have the iPad on a microphone stand but want to place the iPad on Genos.  That would eliminate the need to carry an additional microphone stand.

I currently have this iPad holder which as a 5/8 female thread. 
https://www.bhphotovideo.com/c/product/1333976-REG/auray_ipu_108_universal_tablet_holder.html

To place the iPad directly on the Genos, It looks like i would need to buy the following:

1. Genos Device holder
https://m.thomann.de/gb/millenium_genos_device_holder.htm

2. Short tube
https://m.thomann.de/intl/km_7232000155.htm?i11l=en_GB%3AUS.EUR%3AUSD

3. 3/8 to 5/8 adapter
https://www.ebay.com/itm/5-8-Male-to-3-8-Female-Microphone-Mic-Stand-Adapter-Thread-Screw-W5T6-/222638277743

Thanks again.  Have a great day.

[valimaties]

Vali

thanks a lot for your prompt response. 

I believe that you are 100% right.   Althought the tube included in the K&M 232 that you mentioned has a length of 175mm and the tube i was looking at has a lenght of 130mm but the thread should be the same at 3/8.    That means i would need an adapter from 3/8 to 5/8.

This is what i am considering ordering to adapt an iPad Pro 12.9 inches to the Genos.   I currently have the iPad on a microphone stand but want to place the iPad on Genos.  That would eliminate the need to carry an additional microphone stand.

I currently have this iPad holder which as a 5/8 female thread. 
https://www.bhphotovideo.com/c/product/1333976-REG/auray_ipu_108_universal_tablet_holder.html

To place the iPad directly on the Genos, It looks like i would need to buy the following:

1. Genos Device holder
https://m.thomann.de/gb/millenium_genos_device_holder.htm

2. Short tube
https://m.thomann.de/intl/km_7232000155.htm?i11l=en_GB%3AUS.EUR%3AUSD

3. 3/8 to 5/8 adapter
https://www.ebay.com/itm/5-8-Male-to-3-8-Female-Microphone-Mic-Stand-Adapter-Thread-Screw-W5T6-/222638277743

Thanks again.  Have a great day.

Hi
I have this mic holder from Shure...


I think it is the same thread screw that you want! you don't have one? Or you already use it?
What I want to say is now all mic holders come with this little thread screw! 

Regards,
Vali

[Al Ram]

Vali

Great idea !!!   I have a couple of Shure mics and the mic holders that came with it.    Tonight (it is 2pm here) I will check to see if they came with the adapters.

thanks again.

[valimaties]

Vali

Great idea !!!   I have a couple of Shure mics and the mic holders that came with it.    Tonight (it is 2pm here) I will check to see if they came with the adapters.

thanks again.

Great!
(Here is 00:25) No far away ))

Regards,
Vali

[Al Ram]

Dear  genos Players waiting for the device holder....

Here they are...  made in Germany in solid Aluminium Quality...



http://www.ebay.de/itm/YAMAHA-Device-Holder-Halter-Universell-fur-YAMAHA-GENOS-Keyboard/192398712408?hash=item2ccbdb5e58:g:qiMAAOSwI8laM-Pb

I think eBay will Translate next days and put them in all eBay platforms..

Greetings from Germany
Frank


Ps: for psr Tutorial Member Order via pm Cheaper :-)

Frank

So, is this already available to purchase in USA . . . ?  the last updates indicated 2 weeks. 

Also, has it been tested with iPad Pro 12.9 inches both in portrait and landscape modes . . . . ?

I believe there is also an additional 'joint' piece'

Really want to buy it . . . .

thanks

[JohnS (Ugawoga)]

Where does the battery go???

[Bachus]

Hi ..

Yes, you have to be careful when the mounting is in use. It may be possible with iPad to use a 'buffer' as extra support. It's good that the mounting position is on a radius, which makes it quite strong area.

The holder is today in stock at Thomann .de
https://m.thomann.de/gb/millenium_genos_device_holder.htm?ref=msg_a_2
Previously, a 'set' has been available for Tyros5 at a cost-saving. This is not available option (yet!)
I'll report back when I have mine.

Al.
🎹😊

Its no longer available at Thomann, altough there are alternatives

[valimaties]

I don't recommend this holder. It scratched my Genos (not so visible, but it did it ) even if it has a thin sponge glued on it.

I use now on my K&M Spider Pro keyboard stand (for at least 10 years), this K&M Universal Holder and this adjustable tablet holder, also from K&M

Universal Holder it has a very powerfull strength on Spider stand, and the tablet does not make "motions" ...




Regards,
Vali

[AlBags]

Greets Val!

I also have used a K&M Spider Pro in silver ... Best and strongest stand out there by FAR ... alsoroom underneath for 3-4 pedals!
I use the K&M accessories wherever possible, which fit on the stand.
Brilliant accessories ... really strong.

Al.

[Bachus]

I don't recommend this holder. It scratched my Genos (not so visible, but it did it ) even if it has a thin sponge glued on it.

I use now on my K&M Spider Pro keyboard stand (for at least 10 years), this K&M Universal Holder and this adjustable tablet holder, also from K&M

Universal Holder it has a very powerfull strength on Spider stand, and the tablet does not make "motions" ...

Regards,
Vali

I own the universal k&m tablet holder..
And a K&m double table stand.
But with `genos' in the upper position,
And modx 8 in the lower
It doesn't fit

The genos is to deep, and the tablet holder cant connect
with that depth to the tablestand

I was hoping this would allow me to connect my universal table stand
Directly to the genos...

[Al Ram]

I don't recommend this holder. It scratched my Genos (not so visible, but it did it ) even if it has a thin sponge glued on it.

I use now on my K&M Spider Pro keyboard stand (for at least 10 years), this K&M Universal Holder and this adjustable tablet holder, also from K&M

Universal Holder it has a very powerfull strength on Spider stand, and the tablet does not make "motions" ...




Regards,
Vali

Vali
when you have a chance, can you please send another picture to include the Genos keyboard and the iPad  . . . just to see how everything fits together . . . the Genos, the stand and the iPad, also do you use a microphone for singing ? if so, how do you mount it . . .

thanks in advance.

[AlBags]

I mount my extendable boom mic holder (K&M) on the Genos device holder Thomann sells (or Frank)

Fits/works well, and pretty solid.

I use Genos on the Spider Pro lower arms, top are free, and folded. I use the music stand.

[valimaties]

Vali
when you have a chance, can you please send another picture to include the Genos keyboard and the iPad  . . . just to see how everything fits together . . . the Genos, the stand and the iPad, also do you use a microphone for singing ? if so, how do you mount it . . .

thanks in advance.

Hi Al.
This one (and this one, not so clear) are the only pictures I have with all mounted. I used my Android tablet only to connect to my Behringer X32 Compact mixer. Right now, I don't use anymore my X32, because I want to sell it to buy something else We have a sound team now, the sound system is much bigger, for big events (300-500 people).

Spider has also the connector for microphone stand.



Regards,
Vali

[JohnS (Ugawoga)]

Looks painful!!

[ckobu]

Vali
when you have a chance, can you please send another picture to include the Genos keyboard and the iPad  . . . just to see how everything fits together . . . the Genos, the stand and the iPad, also do you use a microphone for singing ? if so, how do you mount it . . .

thanks in advance.

This might be useful to you. The left is a tablet for my mixer (Behringer XR12) but you can put the Ipad. This stand is home made. The right is the text screen on a flat microphone stand.

[attachment deleted by admin]

[Al Ram]

Vali and Ckobu

Great pictures.  Your setup looks great, very neat, very orderly.

I wonder if the tablet holder can hold an iPad Pro 12.9 inches in portrait mode . . . due to the distances between the stand, the holder and the keyboard . . . 

thanks again.   

[louwe46]

Hey.
Does anyone use the K&M Baby Spider 18840 together with the Tablet holder K & m 19791 for the iPad Pro 12.9 inch?
is there room enough for that ipad?

Can the carrying arms tilt slightly downwards to have a better overview of the Genos?  see picture

I would have liked to hear this.
Thank you.
this is a Google translation.

[attachment deleted by admin]