Pedal 1&2 are switched goes through registers in PSR Yamaha

[chikitin]

Hi,

I just noticed that my Pedals do not act normally. When I press pedal 1: it shows in Fuction>Controller pedal 2 is going though registers 2,3,4, 2,3,4 , 2,3,4 and pedal 2 does not work at all. Pedal 1 constantly showing Sustain.

Any idea what is going on please?

Thank you in advance.
CS

[EileenL]

Go to registration sequence page and make sure it is switched OFF. Your pedals will now work as you had them set.

[chikitin]

Thank you very much. It worked! Pretty nice feature. I was not aware of it.