Error loading Expansion Packs in SX920

Started by Khushroo, Today at 07:15 AM

Previous topic - Next topic

Khushroo

Hi all, 

I have upgraded to SX920 from SX900. I create my Expansion Pack using the Expansion Manager. After creating a pack install file which is a .cpi file, I load it in the SX920 however after going through the full install process at the end it it gives an error message "Failed to access data" and then cancels the installation. I am wondering where I am going wrong cause I had no such problems on the SX900.

Also how can I create a .ppi file as in the YEM the options are .cqi and .cpi

Thanks
  •  

Khushroo

Hi, I figured out its the usb pen drive which was creating all the problems. I had to discard quite a few of them and finally one worked. Thanks
  •  

colas musique

Hello Khushroo,

I'm giving you my opinion, knowing that I could be wrong. If so, other members will correct me.
When you created your pack on the SX 900, you introduced the 900's "instrument info" into the Tarjet, which resulted in a 900's CPI pack. Therefore, it isn't recognized by the 920 since the "instrument info" coded isn't the same.
To give you an example, if I create a CPI pack from my G2, it won't be readable by a friend's G2 for the same reason.
So I advise you to go to the YAMAHA website and download all the free 920 packs and create a new pack from the YEM and the 920's "Instrument info sx 920."

Best Regards, Christia
  •