K&M ipad holder that fits into Genos holes ?

Started by Al Ram, April 05, 2021, 04:59:39 PM

Previous topic - Next topic

Al Ram

Hello Friends

I saw another post where someone says (or I understood) that there is a K&M iPad holder for 12.9 iPad Pro, presumably the K&M iPad holder fits directly into the Genos factory holes made for the music stand.

Anyone knows if this is correct and if so the model ? and can it be used in both portrait and landscape mode ?

(i placed this question in that post but did not get a response).

I currently have the iPad holder attached to a mic stand. The direct fit seems better and one less item to carry around.

Thanks in advance.
AL
San Diego/Tijuana

Bill

England

Current KB:  YAMAHA GENOS 2

Oldden

Anybody know anybody with a 3d printer?. Could be a little earner.

Al Ram

Bill
thanks a lot for the link.  This holder seems like a great idea . . . . it seems to be good for landscape mode . . . not sure if it will allow for Portrait mode using a large iPad Pro 12.9 inches . . . .

I sent an email to vendor asking the question. 

thanks a lot
AL
San Diego/Tijuana

Bill

https://www.thomann.de/gb/km_19790_tablet_stand_holder.htm

It says the holder rotates 360 degs.

You could buy the adaptor with an extension tube and use you existing IPAD holder -

https://www.thomann.de/gb/millenium_genos_tube_set.htm


Bill
England

Current KB:  YAMAHA GENOS 2

Al Ram

Thank you Bill ,,

The extension seems like a good idea for portrait . . . . .

AL
San Diego/Tijuana